Using the VOCAR-PT Clock Utility
--------------------------------
**********************************************************
******** If software is from email, UNZIP THE FILE *******
******** you can unzip the file directly *****************
******** to the directory mentioned below ****************
**********************************************************

1.  Copy ClockUtility.exe to the directory on your PC where the Pro-Tect software is installed.  To easily determine this location:

> Highlight the Pro-Tect icon in the Start Programs list and right-click it
> Select Properties
> In the Properties dialog, select the Find Target button
> Windows will open a directory window for the folder where the Pro-Tect software is installed.

>>>> MAKE SURE PRO-TECT SOFTWARE IS NOT RUNNING <<<<<<<<<<<<<<

2.  Double-click ClockUtility.exe to start it.

3.  Connect your VOCAR-PT to a serial port on your PC and turn the VOCAR-PT on.  In the ClockUtility program, select the appropriate port from the drop-down list.

4.  Click the button marked '1-Set Time'.  This will set the time in the VOCAR-PT to match the current time on your PC.

5.  Click the button marked '3-Set Main'.  This will reset the calibration date of your VOCAR-PT.

6.  Click the 'x' in the upper right corner of the ClockUtility program to exit.

    >>>>>> DO NOT TURN THE VOCAR-PT OFF AFTER SETTING THE DATE!!! <<<<<<

       >>>>>> DO NOT CLICK ANY OTHER BUTTONS IN THE PROGRAM!!! <<<<<<


IMPORTANT: IF YOUR VOCAR-PT HAS A BATTERY FAILURE, IT WILL LOSE ITS CALIBRATION DATE EVERY TIME YOU SHUT IT OFF.  THEREFORE YOU SHOULD LEAVE THE VOCAR-PT TURNED ON AFTER YOU PERFORM THIS PROCEDURE, AND UNTIL YOU ARE DONE CERTIFYING UNITS.

TO RESET THE DATE AGAIN, FOLLOW STEPS 2-6 ABOVE.

DB INNOVATIONS HIGHLY RECOMMENDS THAT YOU SEND YOUR VOCAR-PT IN FOR SERVICE IMMEDIATELY IF THE CALIBRATION DATE HAS BECOME UNUSABLE FOR SOME REASON.